Re: [NTLK] Newton Works import/export

From: Greg Spencer (gspencer_at_sympatico.ca)
Date: Sun Aug 05 2001 - 14:35:27 EDT


I haven't tried this but, first make sure you first save the document in
.rtf format (from the File/Save As dialog). Then import the .rtf document.

Greg

> Hello All,
>
> I have been trying to get my eMate to allow a Microsoft Word document to
> be imported directly from my PC to Newton Works yet with no luck. I tried
to
> import the document as a Rich Text file (*.rtf), yet this leads to either
> the NCU performing an "illegal operation" and being shut down (if Norton
is
> turned off) or simply a crashing of the NCU program via Norton (if I have
> the protection program turned on).
>
> If I try to import the Word document as a Text document (*.txt) the NCU
> tells me that I need to make sure that Newton Works in installed on the
> eMate (which it is) and that I have used it before (which I have).
>
> I have looked over, and then looked over again, the eMate manual but
there
> does not seem to be any help with importing and exporting to the Newton
> Works word processor.
>
> Thus I am stuck. I know that the importing and exporting from Word will
> work, and I could try to send it as a Note to the Newton but this would
> seemed somewhat defeating.
>
> Any help would be appreciated as this is why I got the eMate to begin
> with...
>
> Thank you very, very much,
>
> Sam

--
This is the Newtontalk mailinglist - http://www.newtontalk.net
To unsubscribe or manage: visit the above link or
	mailto:newtontalk-request_at_newtontalk.net?Subject=unsubscribe



This archive was generated by hypermail 2.1.2 : Sun Sep 09 2001 - 19:46:44 EDT