From: L A GREEN (lagoff11_at_yahoo.com)
Date: Tue Apr 13 2004 - 08:52:19 PDT
HOW many instances of slowdown are you using? it is sometimes suggested that 2 or 3 instances are run simoutaneously. ymmv.
hth,
LAG
Mark Einreinhof <montana_at_freeshell.org> wrote:
I recently obtained a well maintained MP2000. I am unable to successfully
connect via the serial cable to the device or complete an action such as
backup or install.
I have the NCU software installed on my Dell Latitude C640 running WinXP
with a Pentium 4 cpu and 512MB ram.
The NCU software and WinXP are both set to use COM3. I tap connect on the
Newton and it does establish a connection as the icons in the NCU
application are no longer greyed out. I pick Backup and the process starts
but after a few seconds the Newton reports "The Connection was stopped
because the PC disconnected." I can pick Install from the Newton and move
through my hard drive's directory structure and I can pick a file to
install. The file then appears to be installing but then fails with the
same explanation.
I have tried different baud rates and that program called slowdown. What
might I do to isolate the problem?
---------------------------------
Do you Yahoo!?
Yahoo! Small Business $15K Web Design Giveaway - Enter today
-- This is the NewtonTalk list - http://www.newtontalk.net/ for all inquiries Official Newton FAQ: http://www.chuma.org/newton/faq/ WikiWikiNewt for all kinds of articles: http://tools.unna.org/wikiwikinewt/
This archive was generated by hypermail 2.1.5 : Tue Apr 13 2004 - 09:00:03 PDT