Re: [NTLK] Escale over Ethernet

From: Allan Hise (allan_at_hise.org)
Date: Sun Feb 20 2005 - 10:49:02 PST

• Next message: Clare Shepherd: "[NTLK] newtontalk Digest V5 #87 Soldering"
• Previous message: Brian Clark: "[NTLK] Registering programs"
• In reply to: Woody Smith: "Re: [NTLK] Escale over Ethernet"
• Next in thread: Woody Smith: "Re: [NTLK] Escale over Ethernet"
• Reply: Woody Smith: "Re: [NTLK] Escale over Ethernet"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]
• Mail actions: [ respond to this message ] [ mail a new topic ]

Unforttuntaley I have no serial port...
It hangs when I install from the mac, from the newton I get the messag e
that the package is damaged.

Any ideas???

Allan

On Sun, 20 Feb 2005, Woody Smith wrote:
>
> Do you have the latest version of Escale installed?
>
> For some folks installing works best from the Mac side.
>
> If you have a serial port you could try NewTen.
>
> Woody
>
>
> On Feb 20, 2005, at 11:15 AM, Allan Hise wrote:
>
> > Interesting that this came up today, because I was about to ask a
> > similar
> > question...
> >

-- 
This is the NewtonTalk list - http://www.newtontalk.net/ for all inquiries
Official Newton FAQ: http://www.chuma.org/newton/faq/
WikiWikiNewt for all kinds of articles: http://tools.unna.org/wikiwikinewt/

• Next message: Clare Shepherd: "[NTLK] newtontalk Digest V5 #87 Soldering"
• Previous message: Brian Clark: "[NTLK] Registering programs"
• In reply to: Woody Smith: "Re: [NTLK] Escale over Ethernet"
• Next in thread: Woody Smith: "Re: [NTLK] Escale over Ethernet"
• Reply: Woody Smith: "Re: [NTLK] Escale over Ethernet"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]
• Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2.1.5 : Sun Feb 20 2005 - 15:00:02 PST