Re: [NTLK] Serail Classic to OS X: using NTK and other tools on new machines?

        A "New Newton 2000" running at about 45 mhz. :)

       At least that was what the dual G4 800 was like.

        But a nice start. This is kinda the case of the Newton & Atari Jaguar... emulators exist, just waiting for the faster machines to run them well.

       Doc Clu

-----Original Message-----
From: newtontalk-bounce@newtontalk.net
[mailto:newtontalk-bounce@newtontalk.net]On Behalf Of matthiasm
Sent: Monday, October 16, 2006 1:04 PM
To: newtontalk@newtontalk.net
Subject: [NTLK] Serail Classic to OS X: using NTK and other tools on new
machines?

Hi everyone,

short introduction: I had a very early Newton just when they came
out, but it got lost over the years. I have hated every PDA ever
since, so finally, when Paul's Einstein went through the press, I
remembered my very first PDA. So here I am with a "brand new" MP2100 ;-)

I'd like to write some software for it and use the debugger, but I
don't have any older Mac. Since my PowerBook seems to be able to run
some things under Classic, I was hoping I could somehow redirect the
original "Modem/Printer Port" on Classic to use the Keyspan adapter
on OS X.

Is that somehow possible? I have been searching hi and low, but
nobody seems to have written anything like this. And my knowledge on
Classic is not good enough. I could do the OS X part though... .

Thanks

  Matthias

-- 
This is the NewtonTalk list - http://www.newtontalk.net/ for all inquiries
Official Newton FAQ: http://www.chuma.org/newton/faq/
WikiWikiNewt for all kinds of articles: http://tools.unna.org/wikiwikinewt/
-- 
This is the NewtonTalk list - http://www.newtontalk.net/ for all inquiries
Official Newton FAQ: http://www.chuma.org/newton/faq/
WikiWikiNewt for all kinds of articles: http://tools.unna.org/wikiwikinewt/