[NTLK] Docking

[Smith Woody]

I apologize it is the 589d that I used.
still if the card isn't recognized when inserted you will need  
additional driver.
I believe that the z3ComDrv:cli is needed

Checked archives and am still unsure about the 589c, but see
<http://marc.info/?l=newtontalk&m=104310966014219&w=2>

this suggests that it does work


On Sep 14, 2011, at 2:47 PM, Max Smith wrote:

> hmmm, in the setup under card, I have options for:
>
> Megahertz 589D
> Megahertz 589DT
> Megahertz 589E
> Farallon Enet PC Card
>
> also, there isn't the driver "z3ComDrv:cli"
>
> will one of the other 589 drivers work fro the 589C?
>
>
> On Sep 14, 2011, at 3:41 PM, Smith Woody wrote:
>
>> To connect to NCU you will use the Dock app.
>> once your newt is connected to the router and your Mac is running  
>> NCU,
>> you will launch Dock, tap "connect to" select "other computer" and
>> hopefully you will your computer running NCU.
>>
>>
>>
>> Good luck
>>
>>
>> On Sep 14, 2011, at 1:12 PM, Max Smith wrote:
>>
>>>
>>>
>>> snip
>>
>>> . I'm trying to connect to an iMac G4 running 10.4.11
>>> and I've downloaded and installed NCU and run it in Classic.
>>>
>>> My question now is, what software do I use on the Newton itself to
>>> connect? I'm assuming the dock application, but there doesn't seem  
>>> to
>>> be a selection for EtherTalk, although if I remember correctly,
>>> EtherTalk was just an implementation of AppleTalk over ethernet.