on 8/30/00 12:49 PM, ZACINCCEO@aol.com at ZACINCCEO@aol.com wrote:
> Dave brings up a good point - if only the main parts of the case
> were to be made (front, back, lid...) the cost would come down, and it would
> take a shorter time to design and produce.
>
That sounds reasonable. Why do we need all the internal case parts to be
aluminum, since they would not be visible anyway?
Alex Karahalios
***************************************
NewtonTalk brought to you by:
EVOTE.COM -- the ESPN of politics on the Internet! All the players, all the news, and the hottest analysis and features (plus 'toons!) anywhere.... visit http://www.evote.com today!
***************************************
Need Subscribe/Unsubscribe info?
Visit the NewtonTalk section at http://www.planetnewton.com
This archive was generated by hypermail 2b29 : Fri Sep 01 2000 - 00:00:15 CDT