Re: [NTLK] another SER-001 installation report

From: Jeremy Bond Shepherd (jbond_at_eskimo.com)
Date: Tue Aug 21 2001 - 16:36:10 EDT


>I DO NOT recomend leaving any screws out. I now know that the
>internal
>connector will fail at some point if you do not securely fasten
>the board
>down.
>That is why I provide the hardware with each board and why I
>mailed everyone
>who bought one, a set of screws.
>A countersink to make the screw head flush is a much better idea.

David,

Can you please explain what 'countersink' means and how to
achieve it.

My SER-001 has been not failed again since I last reinstalled it
with the 2 screws (fingers crossed.) However there still is that
noticeable bulge and gap in the case closure near the pen
holder. If there is some way I could eliminate those then I
would feel better.

Thanks,

-Jeremy

--
This is the Newtontalk mailinglist - http://www.newtontalk.net
To unsubscribe or manage: visit the above link or
	mailto:newtontalk-request_at_newtontalk.net?Subject=unsubscribe



This archive was generated by hypermail 2.1.2 : Sun Sep 09 2001 - 19:47:30 EDT