> David,
> I agree with your description with one exception. My experience is
> that the 1/2" screw prevents complete closure of the locking tab near
> the stylus holder. I can get the case to click as you describe, but
> only when that screw is removed. It sticks out above the PCB just
> enough to cause the bulge and prevent the click. The case closes
> with very minor bulge (above the door) without that screw.
> Suggestions?
>
> Thanks again,
> Chris
Chris,
Is the 1/2" screw fully tightened?
My screw head protrudes above the board also but doesn't prevent me
from fully closing the case.
You could try pressing the two case halves together at that location
while pressing the locking tab location.
If this fails, then my only suggestion would be to run a countersink bit
(or larger diameter drill) in that hole so that the screw head is flush.
I would do this by hand so that you take a minimum of material off.
This will not affect the operation of the board.
Remember, the screw has to be there.
Regards,
David Humphreys
-- This is the Newtontalk mailinglist - http://www.newtontalk.net To unsubscribe or manage: visit the above link or mailto:newtontalk-request_at_newtontalk.net?Subject=unsubscribe
This archive was generated by hypermail 2.1.2 : Sun Sep 09 2001 - 19:49:56 EDT