Steve Weyer <weyer_at_kagi.com> replied
>> Received a -48204 error once (I don't have an error code list - maybe you
>> Laurent ?)
>that means "Path failed" -- any recollection what was happening around
then?
hey Steve
Yeah I do cause I wrote it down - well up to the error appearing anyway. I
didn't notice if the VNC message bar
had anything on display, sorry.
Sequence : eMate - win98 ( thru hub )
Launch VNC ( Prefs -Default )
Entered connection parameters ( IP, Display, P/word )
Tap Connect
'Connect using' Device pop-up up
Tap Connect
-48204 error
So, given that means 'path failed' .......... perhaps the card driver failed
to initialize ?
BTW - This was my second attempt at a connection to the same wintel box.
First launch had been successful
>there's a problem where the NIE link gets "grabbed" but then if there's a
>failure before the endpoint gets created, when VNC attempts to disconnect,
>it thinks it's done but it hasn't released the NIE link -- this leads to
>many problems... I've fixed this and it will be in 3.3a3
Cool!
>RRE does tend to refresh in a "fractal" like fashion.
>next version (maybe later on Fri) won't show all the individual updates
FWIW - Job before this one I used VNC across a NT4 Lan/Wan to
monitor/control IVR ( Integrated Voice Recog )
servers. The refresh on that was similar, though moving the mouse over what
was being altered tended to 'draw' the refresh was a common practice.
Again - Thanks Steve ......!
cheers
Andy
Andy Wells
Systems Administration
EDS Field Support
Launceston, Australia
-- This is the Newtontalk mailinglist - http://www.newtontalk.net To unsubscribe or manage: visit the above link or mailto:newtontalk-request_at_newtontalk.net?Subject=unsubscribe
This archive was generated by hypermail 2.1.2 : Thu Nov 01 2001 - 10:02:21 EST