If you got a knife cutter, a plastic styli from palm, in half an hour,
you can make a new tip for you newton's styli
Ed.Cheung
On Tuesday, April 2, 2002, at 03:05 AM, Marco Mailand wrote:
>
> Am 1.4.2002 8:20 Uhr schrieb "Mick Ring" unter <lists_at_rynosoft.com>:
>> The tip of my stylus became "stripped" of its threads long ago. Is
>> there
>> anyone who makes replacements?
> I've successfully done one so far. It involved a special soft chuck to
> clamp
> the Ti-Stylus into the lathe in order to get the new tip well round and
> right in diameter with respect to the stylus. The new tip I machined
> off one
> of the plastic styli we all bought some months ago (my godness we had
> dozens
> of billions of e-mails in this thread...).
>
> --
> With best Regards / Viele Gruesse!
>
> Marco Mailand
>
> http://slsbd.psi.ch/timing
> http://slsbd.psi.ch/~mmailand/
> https://www.paypal.com/refer/pal=YYD3VUXUVD2YG
>
>
>
> --
> Read the List FAQ/Etiquette: http://www.newtontalk.net/faq.html
> Read the Newton FAQ: http://www.guns-media.com/mirrors/newton/faq/
> This is the NewtonTalk mailing list - http://www.newtontalk.net
>
-- Read the List FAQ/Etiquette: http://www.newtontalk.net/faq.html Read the Newton FAQ: http://www.guns-media.com/mirrors/newton/faq/ This is the NewtonTalk mailing list - http://www.newtontalk.net
This archive was generated by hypermail 2.1.2 : Sun May 05 2002 - 14:02:04 EDT