The most easy is with Quick figure works, the works spread sheet, you can
enter "=viewautopsy(1)" and tap the check mark.
You can try with ViewFrame, write "viewautopsy(1)" in the "command line" and tap
"eval".
Also, for the freaky, the number in viewautopsy tells the newton how many
milliseconds to wait before drawing the next view. You can try with higher
values. To turn it off enter "viewautopsy(0)".
Plus, for the very freaky, enter "viewautopsy(nil)" and you'll see a box
showing the viewbounds of every view on the screen. Enter the same again to
turn it off.
Daniel Padilla
>
> on 25-04-2002 8:21, Daniel Padilla at daniel.padilla_at_wanadoo.es wrote:
>
> > You can try to write: viewautopsy(1) in any NewtonScript compiler program.
> > With this, i started to see the ball moving!.
>
> Can you do this on the Newt ?
>
> And if yes, what would be a good 'NewtonScript compiler program' ?
>
-- Read the List FAQ/Etiquette: http://www.newtontalk.net/faq.html Read the Newton FAQ: http://www.guns-media.com/mirrors/newton/faq/ This is the NewtonTalk mailing list - http://www.newtontalk.net
This archive was generated by hypermail 2.1.2 : Sun May 05 2002 - 14:05:09 EDT