Robert, I'm going to describe my setup and hopefully it'll help you out.
In my Owner's card, I have two e-mail addresses entered (they're designated as E-Mail, not Internet). Don't fill in the =
e-mail password field here. I then have two SimpleMail entries, one for each address. This is for authentication and su=
ch. There's a checkbox right at the top to enable or disable the entry. Below that the usual POP/IMAP login into, and S=
MTP server and login info if necessary.
In InOut->i->SimpleMail prefs, there shouldn't be anything special. Maybe you should go to the Debug panel there though =
and capture All I/O (it goes to Notes) and then try to connect, and view the debug output afterwards. You might need to =
install the special debug version of SimpleMail for this, I can't remember, it's on the SimpleMail page somewhere.
HTH.
-V
Original Message:
-----------------
From: Robert Benschop rbenschop_at_euronet.nl
Date: Fri, 06 Dec 2002 14:48:19 +0100
Subject: Re: [NTLK] SimpleMail question
It was 'browse mail', just changed to 'download mail' but still only mail
from one account, and no checkboxes so far...
-------------------------------------------------------------------
This message has been posted from Mail2Web http://www.mail2web.com/
Web Hosting for $9.95 per month! Visit: http://www.yourhosting.com/
-------------------------------------------------------------------
-- This is the NewtonTalk list - http://www.newtontalk.net/ for all inquiries List FAQ/Etiquette/Terms: http://www.newtontalk.net/faq.html Official Newton FAQ: http://www.chuma.org/newton/faq/
This archive was generated by hypermail 2.1.2 : Wed Jan 01 2003 - 10:01:56 EST