I just received my 3Com 3CCE589ET ethernet card from our own Simon
Muller(thanks Simon!), and went to the chuma ethernet set up page to
get it all working. I had NIE 2.0, as well as Newton Internet 2.0
installed. So I installed the Newton Devices package, and the 3Com 589
driver, the 3Com addon package, and the Farallon driver package. Then I
inserted the card and the Newt identified it as a "3Com Megahertz"
card. So far, so good. I then went into Internet Setup to create a new
set up. However, in the "connect using" box, I don't get the ethernet
option. After going back over the instructions, I noticed a mention of
an NIE Ethernet package, but I don't see that on my Newt, and I can't
find it on my UNNA cd's. Is this the missing piece of the puzzle? And
where can I find it?
Thanks!
John
"Got Newt!"
-- This is the NewtonTalk list - http://www.newtontalk.net/ for all inquiries List FAQ/Etiquette/Terms: http://www.newtontalk.net/faq.html Official Newton FAQ: http://www.chuma.org/newton/faq/
This archive was generated by hypermail 2.1.2 : Wed Jan 01 2003 - 10:02:49 EST