Finished the upgrade about an hour ago. Everything tests great so far!
Took a couple of hours.
I don't have a SER-001 so I installed the switch and both crystal's in
the open space.
I had lots of trouble removing the old crystal. In the end I added extra
solder to both connections( better heat transfer from the iron). Then
pulling(gently) on the crystal with a small pair if pliers I applied
heat on one side and then the other. After a few cycles the old crystal
lifted without any damage to the Newt.
Thanks Stephanie!
-- This is the Newtontalk mailinglist - http://www.newtontalk.net To unsubscribe or manage: visit the above link or mailto:newtontalk-request_at_newtontalk.net?Subject=unsubscribe
This archive was generated by hypermail 2.1.2 : Fri Feb 01 2002 - 16:02:54 EST