> I don't know if it will be suitable but you might like to read about 3M
> #7303 Z-Axis film for bonding flexible connectors to pcb:
It looks very interesting, except the need of heat to cure the glue. I've
not yet found what temperature is needed and how long but this will decide
about applicability (?). If the heat required exceeds e.g. 80 deg C it will
probably melt the BL foil :-(
I'll check the internet for conductive epoxy too, which cures at room
temperature.
-- With best regards / Viele GruesseMarco Mailand http://slsbd.psi.ch/timing http://slsbd.psi.ch/~mmailand https://www.paypal.com/refer/pal=YYD3VUXUVD2YG
-- Read the List FAQ/Etiquette: http://www.newtontalk.net/faq.html Read the Newton FAQ: http://www.guns-media.com/mirrors/newton/faq/ This is the NewtonTalk mailing list - http://www.newtontalk.net
This archive was generated by hypermail 2.1.2 : Wed Jun 12 2002 - 20:02:36 EDT