Re: [NTLK] installing an SER-001

From: Peter Cameron (pdwc_at_sympatico.ca)
Date: Fri Oct 04 2002 - 12:59:39 EDT

Next message: Mike Drabicki: "Re: [NTLK] NYCnug, Well..."
Previous message: Laurent Daudelin: "Re: [NTLK] Wireless"
In reply to: Paul Vaughan: "[NTLK] installing an SER-001"
Next in thread: Woo Lee: "Re: [NTLK] installing an SER-001"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]
Mail actions: [ respond to this message ] [ mail a new topic ]

on 10/4/02 5:52 AM, Paul Vaughan at paulsvaughan_at_yahoo.com.au wrote:
> Is this a normal result of installing the SER-001, or
> should I reopen the case and reseat the SER-001.
Make sure the SER-001 is seated properly and screwed down. There will
still be a slight bump on the back with some Newtons, but I've found
reseating usually makes it minimal and the door should stay in the clips OK.

Peter

-- 
Read the List FAQ/Etiquette: http://www.newtontalk.net/faq.html
Read the Newton FAQ: http://www.chuma.org/newton/faq/
This is the NewtonTalk mailing list - http://www.newtontalk.net/

Next message: Mike Drabicki: "Re: [NTLK] NYCnug, Well..."
Previous message: Laurent Daudelin: "Re: [NTLK] Wireless"
In reply to: Paul Vaughan: "[NTLK] installing an SER-001"
Next in thread: Woo Lee: "Re: [NTLK] installing an SER-001"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]
Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2.1.2 : Thu Oct 31 2002 - 12:02:07 EST