From: Paul Curtis (MicroSSG_at_Comcast.net)
Date: Tue Dec 09 2003 - 14:38:06 PST
OK, I started HT and configured for Comm1, when I hit a key I get an
error message that another device is using the port, wait until that
device is done, close HT and restart. I did that and get the same
message. The MP 120 was turned off the whole time.
Regards,
Paul Curtis
-----Original Message-----
From: newtontalk-bounce_at_newtontalk.net
[mailto:newtontalk-bounce_at_newtontalk.net] On Behalf Of Andrei Chichak
Sent: Tuesday, December 09, 2003 2:23 PM
To: newtontalk_at_newtontalk.net
Subject: Re: [NTLK] Newbie question about transferring data from one
Newt to another...
At 02:15 PM 12/9/2003 -0800, you wrote:
>The blipping is when I tap the connect on the MP 120, if it's not
>connected and I tap connect, how could the Belkin blip?
Ah yes, I see...okay try this, shut down NCU, fire up hyperterm and hold
down a key, does the other light blink?
A
-- This is the NewtonTalk list - http://www.newtontalk.net/ for all inquiries List FAQ/Etiquette/Terms: http://www.newtontalk.net/faq.html Official Newton FAQ: http://www.chuma.org/newton/faq/ -- This is the NewtonTalk list - http://www.newtontalk.net/ for all inquiries List FAQ/Etiquette/Terms: http://www.newtontalk.net/faq.html Official Newton FAQ: http://www.chuma.org/newton/faq/
This archive was generated by hypermail 2.1.5 : Tue Dec 09 2003 - 16:30:00 PST