From: mjoslin_at_dial.pipex.com
Date: Sat Nov 08 2003 - 00:24:51 PST
Thanks for your reply and I have made the changes you suggested but to no
apparant avail
The set up is as follows
TG4 running Panther with classic 9.2 underneath
The 2100 seems to have the required software in that it has a 3Com card
3CXE589EC and the drivers installed plus a cat 5 cable
When I insert card it shows up on the newt and I have ticked the apple talk
button as suggested.
I have tried to see the card from within Classic and Panther
What I am not sure about is will I be able to see the device on the TG4 desktop
after I have configured the prefs for ethernet appletalk etc.
There are so many settings in Panther I am not sure if I changing too many or
not enough.
Is there some where were I can put in nodes and network info into the Newt that
I am missing?
I would appreciate any help you can give
Thanks
Mike Joslin
Quoting Laurent Daudelin <laurent.daudelin_at_verizon.net>:
> on 07/11/03 17:24, mjoslin_at_dial.pipex.com at mjoslin_at_dial.pipex.com wrote:
>
> > Is there anything worse than a proud owner of a G4 laptalk and a very
> recent
> > 2100 Newton owner who asks the same boring message with no real clues??
> > I would however be very pleased to recieve some directions to the solution
> of
> > getting a 2100 talking through ethernet to a G4 powerbook running Panther
> > I have a crossover cable and a 3Com 3CXE589EC ethernet card and have set
> up
> > as
> > far as possible following various articles Apple talk/ethernet etc.
> > I think I have most of the software loaded onto the Newton (as it came
> from
> > the
> > supplier) but not sure of how to proceed as I am not able to load any more
> > until this problem is solved.
> > Please forgive this lame approach but any directions will be gratefully
> > recieved
>
> If you're using NCU under Classic, you need to set it to use AppleTalk.
> Then, make sure that AppleTalk is turned on in the Network preference under
> OS X. On the Newton, when you insert your Ethernet card, you should get a
> slip. On that slip should be a setting saying "Use card for AppleTalk" and
> you should be set.
>
> -Laurent.
> --
> ============================================================================
> Laurent Daudelin AIM/iChat: LaurentDaudelin <http://nemesys.dyndns.org>
> Logiciels Nemesys Software mailto:laurent.daudelin_at_verizon.net
>
> case and paste n.: [from `cut and paste'] 1. The addition of a new feature
> to an existing system by selecting the code from an existing feature and
> pasting it in with minor changes. Common in telephony circles because most
> operations in a telephone switch are selected using case statements. Leads
> to software bloat.
>
> --
> This is the NewtonTalk list - http://www.newtontalk.net/ for all inquiries
> List FAQ/Etiquette/Terms: http://www.newtontalk.net/faq.html
> Official Newton FAQ: http://www.chuma.org/newton/faq/
>
>
-- -- This is the NewtonTalk list - http://www.newtontalk.net/ for all inquiries List FAQ/Etiquette/Terms: http://www.newtontalk.net/faq.html Official Newton FAQ: http://www.chuma.org/newton/faq/
This archive was generated by hypermail 2.1.5 : Sat Nov 08 2003 - 01:30:00 PST