From: Jim Witte (jswitte_at_bloomington.in.us)
Date: Thu Aug 26 2004 - 22:13:09 PDT
> anything. Should the pins seat in the Newton really obviously? I don't
> want to force it.
As I recall, the board does take an extra little "push" to seat the
pins all the way. Make sure that the pins are lined up with the
internal connector, though - one row off the edge *might* bend it out a
little, which would be a pain.. (Might because I don't know whether
the edge thickness of the Newt-side connector is greater than the
inter-pin distance) If the thing is lined up properly, the serial port
block will fit almost *exactly* into the little square area - it really
is quite a good fit.
Jim
-- This is the NewtonTalk list - http://www.newtontalk.net/ for all inquiries Official Newton FAQ: http://www.chuma.org/newton/faq/ WikiWikiNewt for all kinds of articles: http://tools.unna.org/wikiwikinewt/
This archive was generated by hypermail 2.1.5 : Thu Aug 26 2004 - 23:00:02 PDT