Re: [NTLK] Mother Boards

From: Johannes Wolf (mp2100_at_mail-gw.estec.esa.int)
Date: Tue Jan 13 2004 - 06:42:28 PST


The point is that in case you have no comparison it is rather hard to decide
whats a small gap and what is a wider one...
I assume you mean the gap in the middle of pin rows, because the distance
between two subsequent pins within one row is the same for both chips.

Cheers
Johannes

> -----Original Message-----
> From: newtontalk-bounce_at_newtontalk.net
> [mailto:newtontalk-bounce_at_newtontalk.net]On Behalf Of Manuel Probsthain
> Sent: Tuesday, January 13, 2004 2:50 PM
> To: newtontalk_at_newtontalk.net
> Subject: Re: [NTLK] Mother Boards

> Johannes Wolf wrote:

> >If the 4 Meg chips are monted they are located close to the ROM
> piggy board
> >connector while the 2 Meg chips have to be monted a little bit
> shifted away
> >from that connector.

> The 2 Meg chips are the smaller ones, use the smaller soldering pads and
> have also very small gaps between the pins.

> Short but to the point... ;-)

> cu
> Manu

-- 
This is the NewtonTalk list - http://www.newtontalk.net/ for all inquiries
List FAQ/Etiquette/Terms: http://www.newtontalk.net/faq.html
Official Newton FAQ: http://www.chuma.org/newton/faq/


This archive was generated by hypermail 2.1.5 : Tue Jan 13 2004 - 07:00:01 PST