Re: [NTLK] Direct connection Mac and Newton

From: Martin Joseph (martyNT_at_barknaturalpet.com)
Date: Wed Jan 21 2004 - 18:49:57 PST

• Next message: Keyes Kurt: "Re: [NTLK] HELP!"
• Previous message: Dan: "Re: [NTLK] AvailWorks 3.0"
• In reply to: Frank Gruendel: "Re: [NTLK] Direct connection Mac and Newton"
• Next in thread: Laurent Daudelin: "Re: [NTLK] Direct connection Mac and Newton"
• Reply: Laurent Daudelin: "Re: [NTLK] Direct connection Mac and Newton"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]
• Mail actions: [ respond to this message ] [ mail a new topic ]

Interestingly I tested this here with a B/W G3 900 and my 2100 after we
discussed it in the previous thread, and it would not connect with two
different good crossover cables.

My ethernet card is a 3com 389d or whatever is close to that

Even using Escale, I needed to use my hub to connect, and then it
worked perfectly...

Clearly there is some hardware/autosensing issue with some mac hardware
in this crossover cable case.

Marty

-- 
This is the NewtonTalk list - http://www.newtontalk.net/ for all inquiries
List FAQ/Etiquette/Terms: http://www.newtontalk.net/faq.html
Official Newton FAQ: http://www.chuma.org/newton/faq/

• Next message: Keyes Kurt: "Re: [NTLK] HELP!"
• Previous message: Dan: "Re: [NTLK] AvailWorks 3.0"
• In reply to: Frank Gruendel: "Re: [NTLK] Direct connection Mac and Newton"
• Next in thread: Laurent Daudelin: "Re: [NTLK] Direct connection Mac and Newton"
• Reply: Laurent Daudelin: "Re: [NTLK] Direct connection Mac and Newton"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]
• Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2.1.5 : Wed Jan 21 2004 - 20:00:02 PST