From: Martin Joseph (martyNT_at_barknaturalpet.com)
Date: Tue Jul 13 2004 - 13:05:17 PDT
On Jul 13, 2004, at 12:19 PM, Andrew C.Rempt wrote:
> Sorry, but a few more questions from some one else thinking about the
> board.
>
>> It's very easy actually, look over Frank's excellent take apart, even
>> though it goes way further then you need to...
>
> But where does one need to stop? Also, where does the board go and how
> easily does it go in? Does it need to be soldered, or are there obvious
> connections?
You only need to take the back off....
Then you need to make sure the SER001 is fully seated.
There is no soldering.
Marty
-- This is the NewtonTalk list - http://www.newtontalk.net/ for all inquiries Official Newton FAQ: http://www.chuma.org/newton/faq/ WikiWikiNewt for all kinds of articles: http://tools.unna.org/wikiwikinewt/
This archive was generated by hypermail 2.1.5 : Fri Jul 16 2004 - 08:03:20 PDT