From: Richard Chamberlain (newton_at_sunsetandlabrea.com)
Date: Fri May 21 2004 - 10:49:35 PDT
Hello,
>> Any suggestions?
> Try running the OS9 keyspan installer from classic. It just adds some
> extensions, as I recall. You'll need to restart classic afterwards (of
> course).
>
> You can actually drag and drop the classic system folder from your imac
> to the PBG4, and then use the "classic" preference panel in OSX to
> designate the newly dropped system folder as your classic system
>
> You should then be able to start it up (from OSX).
>
> Paul G. has clearly stated that there are some advantages to running
> under OSX, particularly the fact that Hammer behaves a little better.
> So this seems to be a workable way to go.
OK I've done that.
I can now see the keyspan in classic and in Toolkit preferences I've set
the type to Serial and the Port to the Keyspan adapter.
When I try and connect the inspector I get:
"Could not complete your request because the selected Serial Port is busy
(is AppleTalk active? Or is port being used by a modem or some other
application?"
Is this because I have both OS X and Classic drivers installed now?
Ideally I'd like to keep both so I don't have to boot classic just to
install a pkg.
Thanks so much for your help so far.
Cheers,
Richard
-- This is the NewtonTalk list - http://www.newtontalk.net/ for all inquiries Official Newton FAQ: http://www.chuma.org/newton/faq/ WikiWikiNewt for all kinds of articles: http://tools.unna.org/wikiwikinewt/
This archive was generated by hypermail 2.1.5 : Fri May 21 2004 - 12:00:02 PDT