Re: [NTLK] Laserjet 6P

From: Edmund Blackadder (edmund_at_helmug.gr)
Date: Fri May 28 2004 - 16:23:54 PDT

• Next message: Dan: "Re: [NTLK] eMate disassembly - do I *have* to de-solder?"
• Previous message: James Johnston: "Re: [NTLK] Laserjet 6P"
• In reply to: James Johnston: "Re: [NTLK] Laserjet 6P"
• Next in thread: James Johnston: "Re: [NTLK] Laserjet 6P"
• Reply: James Johnston: "Re: [NTLK] Laserjet 6P"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]
• Mail actions: [ respond to this message ] [ mail a new topic ]

On 29 May 2004, at 00:11, James Johnston wrote:

>
> On May 28, 2004, at 3:11 PM, Edmund Blackadder wrote:
>
>> Hi list,
>>
>> do u know if HP Laser Jet 6P works with print pack 2??
>>
>> I could find it listed anywhere.
>>
> Yes, but, best of all it works with IRDA just make sure you have the
> IRDA patch installed or it takes forrrrreeeeeevvvvvvveeeeerr.
>

You mean the HP-IrDA driver?

Thanks

Kostas

-- 
This is the NewtonTalk list - http://www.newtontalk.net/ for all inquiries
Official Newton FAQ: http://www.chuma.org/newton/faq/
WikiWikiNewt for all kinds of articles: http://tools.unna.org/wikiwikinewt/

• Next message: Dan: "Re: [NTLK] eMate disassembly - do I *have* to de-solder?"
• Previous message: James Johnston: "Re: [NTLK] Laserjet 6P"
• In reply to: James Johnston: "Re: [NTLK] Laserjet 6P"
• Next in thread: James Johnston: "Re: [NTLK] Laserjet 6P"
• Reply: James Johnston: "Re: [NTLK] Laserjet 6P"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]
• Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2.1.5 : Fri May 28 2004 - 20:30:03 PDT