From: Dan (dan_at_dbdigitalweb.com)
Date: Mon May 31 2004 - 12:33:17 PDT
>On 31-mei-04, at 19:28, Len Cole wrote:
>> Since the connector is only a bakelite-type plastic, you might be able
>> to nibble away at the bottom portion of the "block" with an Xacto
>> knife "chisel" blade end get it narrow enough to accept both voltage
>> cards. It's close-in work, but you just might be able to do it.
>
>Wouldn't drilling be the better way here? I'd prefer that to chiseling.
>(and I mean a very fine drill of course...)
Nah a Dremil would work better I should think (as they are designed for fine
work) ;)
-Dan
-- This is the NewtonTalk list - http://www.newtontalk.net/ for all inquiries Official Newton FAQ: http://www.chuma.org/newton/faq/ WikiWikiNewt for all kinds of articles: http://tools.unna.org/wikiwikinewt/
This archive was generated by hypermail 2.1.5 : Mon May 31 2004 - 13:00:03 PDT