Re: [NTLK] Cutting open golf balls (OT)

From: Josef Chessor (josefcub_at_gmail.com)
Date: Fri Sep 10 2004 - 08:22:20 PDT

Next message: Christopher Zinkula: "Re: [NTLK] Cutting open golf balls (OT)"
Previous message: NewtonMP - Paul Curtis: "Re: [NTLK] Cutting open golf balls (OT)"
In reply to: NewtonMP - Paul Curtis: "Re: [NTLK] Cutting open golf balls (OT)"
Next in thread: Christopher Zinkula: "Re: [NTLK] Cutting open golf balls (OT)"
Reply: Christopher Zinkula: "Re: [NTLK] Cutting open golf balls (OT)"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]
Mail actions: [ respond to this message ] [ mail a new topic ]

You know, I hope that if I lose my Newton, people'll go this far for
me, too. Jon, you're very lucky. :)

On Fri, 10 Sep 2004 11:18:41 -0400, NewtonMP - Paul Curtis
<paul.curtis_at_newtonmp.com> wrote:
> Jon - Send me your darn address already!
>
> Paul Curtis

-- 
This is the NewtonTalk list - http://www.newtontalk.net/ for all inquiries
Official Newton FAQ: http://www.chuma.org/newton/faq/
WikiWikiNewt for all kinds of articles: http://tools.unna.org/wikiwikinewt/

Next message: Christopher Zinkula: "Re: [NTLK] Cutting open golf balls (OT)"
Previous message: NewtonMP - Paul Curtis: "Re: [NTLK] Cutting open golf balls (OT)"
In reply to: NewtonMP - Paul Curtis: "Re: [NTLK] Cutting open golf balls (OT)"
Next in thread: Christopher Zinkula: "Re: [NTLK] Cutting open golf balls (OT)"
Reply: Christopher Zinkula: "Re: [NTLK] Cutting open golf balls (OT)"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]
Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2.1.5 : Fri Sep 10 2004 - 08:30:02 PDT