From: Moe (hugeu2fan_at_gmail.com)
Date: Fri May 06 2005 - 15:27:10 PDT
Paul,
Must I install anything or configure anything on my 2400c after
porting these packages to the Newton? Or is this all I need then I
should be headache free? Thanks!
Morris
On 5/6/05, Paul Curtis (Nations One Mortgage) <MicroSSG_at_comcast.net> wrote:
> Morris,
>=20
> Stop what you're doing and go to Eckhart K=3DF6ppen's website, =3D
> www.40hz.org and
> download the following programs and be done with it...
>=20
> Nitro
> Neo
> IC/VC=3D20
>=20
> Best Regards,
>=20
> Paul Curtis
> Certified Mortgage Planner
> BBC Group, a division of Nations One Mortgage
>=20
> (517) 775-6666 Cell (Voice Mail)
> (517) 579-3283 Office
> (866) 263-2956 Toll-Free Office
> (517) 548-9735 Facsimile
> Curtis_at_BBCGroupMI.com=3D20
-- This is the NewtonTalk list - http://www.newtontalk.net/ for all inquiries Official Newton FAQ: http://www.chuma.org/newton/faq/ WikiWikiNewt for all kinds of articles: http://tools.unna.org/wikiwikinewt/
This archive was generated by hypermail 2.1.5 : Fri May 06 2005 - 20:00:01 PDT