I'll take this bit of advice. This is how I did my eMac. It's by far
the best way of doing things. It may take the longest too but there
will be no regrets.
Alex
On Sep 7, 2006, at 11:47 PM, flying canoe wrote:
> Either print out the pages for this job from either the service
> manual or
> the website and as you go, stick the screws onto the page that
> shows them so
> that when you start reassembling you can tell what goes where.
-- This is the NewtonTalk list - http://www.newtontalk.net/ for all inquiries Official Newton FAQ: http://www.chuma.org/newton/faq/ WikiWikiNewt for all kinds of articles: http://tools.unna.org/wikiwikinewt/Received on Fri Sep 8 17:48:09 2006
This archive was generated by hypermail 2.1.8 : Fri Sep 08 2006 - 20:30:00 EDT