[NTLK] Enabling serial channel 3 on newton interconnect port

[Bhavishya Goel]

Isn't anyone here who can help me with serial channel 3 on interconnect
port?

<bhavishya.goel at gmail.com> wrote:

> *Bhavishya Goel* bhavishya.goel at gmail.com
> <newtontalk%40newtontalk.net?Subject=Re:%20%5BNTLK%5D%20Enabling%20serial%20channel%203%20on%20newton%20interconnect%20port&In-Reply-To=%3C3feae5231003122236gdb60020o486d5f4dea173148%40mail.gmail.com%3E>
> *Fri Mar 12 22:36:19 PST 2010*
>
>    - Previous message: [NTLK] Repeating Dates
>    <http://lists.newtontalk.net/pipermail/newtontalk/2010-March/002745.html>
>    - Next message: [NTLK] The Stanford Newton User Group March 2010
>    <http://lists.newtontalk.net/pipermail/newtontalk/2010-March/002737.html>
>    - *Messages sorted by:* [ date ]<http://lists.newtontalk.net/pipermail/newtontalk/2010-March/date.html#2736> [
>    thread ]<http://lists.newtontalk.net/pipermail/newtontalk/2010-March/thread.html#2736> [
>    subject ]<http://lists.newtontalk.net/pipermail/newtontalk/2010-March/subject.html#2736> [
>    author ]<http://lists.newtontalk.net/pipermail/newtontalk/2010-March/author.html#2736>
>
> ------------------------------
>
> Hi,
>
> I am trying to use the serial channel 3 available on the Newton Interconnect
> Port of Messagepad 2100. But I am not sure how to enable it. The Newton
>
> Interconnect guide says that one should refer to Newton Programmer's guide
> to know how to access this channel. But the Newton Programmer's Guide and
> Newton programmer's reference are totally silent about differentiating
>
> between different serial channels either on the interconnect port or
> internal serial slot. After rummaging through the two said manuals for some
> time, I guessed that "serial chip location" (kCMOSerialHWChipLoc) option
>
> mentioned in chapter 24 was the way to go,  but it doesn't explicitly talk
> about different channels. I tried changing the different values for this
> option, but I didn't see any activity on serial channel 3 (only on serial
>
> channel 0). Can someone tell me how can I tell Newton to use serial channel
> 3 instead of channel 0 on the interconnect port and how to drive the
> InternalMdmSelect signal?
>
> Thanks
>
>
>
> ====================================================================
> The NewtonTalk Mailing List - http://newtontalk.net/
> The Official Newton FAQ     - http://splorp.com/newton/faq/
> The Newton Glossary         - http://splorp.com/newton/glossary/
> WikiWikiNewt                - http://tools.unna.org/wikiwikinewt/
> ====================================================================
>