[NTLK] Docking
Max Smith
maxmaxmaxmaxsmith at gmail.com
Wed Sep 14 15:47:24 EDT 2011
hmmm, in the setup under card, I have options for:
Megahertz 589D
Megahertz 589DT
Megahertz 589E
Farallon Enet PC Card
also, there isn't the driver "z3ComDrv:cli"
will one of the other 589 drivers work fro the 589C?
On Sep 14, 2011, at 3:41 PM, Smith Woody wrote:
> To connect to NCU you will use the Dock app.
> once your newt is connected to the router and your Mac is running NCU,
> you will launch Dock, tap "connect to" select "other computer" and
> hopefully you will your computer running NCU.
>
>
>
> Good luck
>
>
> On Sep 14, 2011, at 1:12 PM, Max Smith wrote:
>
>>
>>
>> snip
>
>> . I'm trying to connect to an iMac G4 running 10.4.11
>> and I've downloaded and installed NCU and run it in Classic.
>>
>> My question now is, what software do I use on the Newton itself to
>> connect? I'm assuming the dock application, but there doesn't seem to
>> be a selection for EtherTalk, although if I remember correctly,
>> EtherTalk was just an implementation of AppleTalk over ethernet.
>
>
> ====================================================================
> The NewtonTalk Mailing List - http://newtontalk.net/
> The Official Newton FAQ - http://splorp.com/newton/faq/
> The Newton Glossary - http://splorp.com/newton/glossary/
> WikiWikiNewt - http://tools.unna.org/wikiwikinewt/
> ====================================================================
More information about the NewtonTalk
mailing list