Re: [NTLK] NetGear MR814 with Wired Connection

From: Robert Benschop (rbenschop_at_euronet.nl)
Date: Tue Dec 16 2003 - 06:41:26 PST


On 16-dec-03, at 15:01, Eric Schneck wrote:
> The newton does not show up at all on the 814 status page, although
> the Mac does.

Can you connect to your Mac running NCU?
Is you set your PowerBook to DHCP? What do you see under 'Built-in
Ethernet'? If Configure IPv4 is set to 'Using DHCP' you should be able
to see the IP address your router assigned to your PowerBook.
(just checking that your router hands out the IP addresses alright)
In the Internet Setup on your Newt all you need (in case the DHCP works
fine) is 'Configuration: DHCP server' and 'Card: whatever card you're
using' next you fill in a domain name and you should be set.
BTW, could you surf on the net before? (as in, do you have all of the
NIE packages installed?)

Good luck,

Robert Benschop

-- 
This is the NewtonTalk list - http://www.newtontalk.net/ for all inquiries
List FAQ/Etiquette/Terms: http://www.newtontalk.net/faq.html
Official Newton FAQ: http://www.chuma.org/newton/faq/


This archive was generated by hypermail 2.1.5 : Tue Dec 16 2003 - 07:00:01 PST