From: Jeff Henry (j3ff_at_comcast.net)
Date: Wed Apr 28 2004 - 00:01:45 PDT
> I used the PC-> Newton cable with a gender adaptor male/male and the cisco
db9 to rollover cable. PT100 and TermLimit both says its connected at 0bps
but nothing appears on the screen. I also tried using a 25pin serial cable
to mac din cable.. same results.. so is it the cable i'm using.. my boss
mentioned something about a null modem cable with a db9 on one end and a mac
din on the other...
>
> Any help is certainly appreciated!
Try using a rollover > null modem > newt cable. That should do the trick at
least it works for me. Also make sure your settings are right 9600,8,n,1
none for flow control. I havent used my newt on a router in a while but I
just hooked it up to my 1751 and it works fine. Hope that helps.
Jeff
-- This is the NewtonTalk list - http://www.newtontalk.net/ for all inquiries Official Newton FAQ: http://www.chuma.org/newton/faq/ WikiWikiNewt for all kinds of articles: http://tools.unna.org/wikiwikinewt/
This archive was generated by hypermail 2.1.5 : Wed Apr 28 2004 - 00:30:01 PDT