The door clasp is held in place by a slightly flexing "D" shaped
piece of plastic with a nub in the middle, which fits into a rectanglar
well on the back cover - the slot is on the inside - the depth facing
the outside. The D shaped piee is on the inner side of the clasp, away
from the "longer" end of the visiblecurved clasp. there are two L
shaped pegs pointing up from the visible clasp. These pop into the two
slots below the well on the back cover - toward the middle of the Newt.
To extract the old clasp, push the two L-pegs inward from the sides,
and it will slide out. To put the new one in, make sure to set the D
shaped flex part in it's slot toward the top of the Newton (for the top
clasp) before inserting the L-pegs.
Jim
> I just wish I knew how to install a replacement clasp in
> the event I actually get my hands on one. :-)
-- Read the List FAQ/Etiquette: http://www.newtontalk.net/faq.html Read the Newton FAQ: http://www.guns-media.com/mirrors/newton/faq/ This is the NewtonTalk mailing list - http://www.newtontalk.net
This archive was generated by hypermail 2.1.2 : Sun May 05 2002 - 14:05:34 EDT