Excellent. Thank you very much. Now, all I need to do is find one of the
dang things. :)
Michael Mays
*******
Pie iesu domine, dona eis requiemmmm... *whack*
-------
-----Original Message-----
From: newtontalk-bounce_at_newtontalk.net
[mailto:newtontalk-bounce_at_newtontalk.net] On Behalf Of Jim Witte
Sent: Tuesday, April 30, 2002 1:20 PM
To: newtontalk_at_newtontalk.net
Subject: Re: [NTLK] Installing MP2x00 Door Clasp
The door clasp is held in place by a slightly flexing "D" shaped
piece of plastic with a nub in the middle, which fits into a rectanglar
well on the back cover - the slot is on the inside - the depth facing
the outside. The D shaped piee is on the inner side of the clasp, away
from the "longer" end of the visiblecurved clasp. there are two L
shaped pegs pointing up from the visible clasp. These pop into the two
slots below the well on the back cover - toward the middle of the Newt.
To extract the old clasp, push the two L-pegs inward from the sides,
and it will slide out. To put the new one in, make sure to set the D
shaped flex part in it's slot toward the top of the Newton (for the top
clasp) before inserting the L-pegs.
Jim
<snip>
-- Read the List FAQ/Etiquette: http://www.newtontalk.net/faq.html Read the Newton FAQ: http://www.guns-media.com/mirrors/newton/faq/ This is the NewtonTalk mailing list - http://www.newtontalk.net
This archive was generated by hypermail 2.1.2 : Sun May 05 2002 - 14:05:34 EDT