Re: [NTLK] Small part needed

From: doppler (roman_at_pixell.net)
Date: Fri Jan 16 2004 - 09:41:12 PST

• Next message: Anil: "Re: [NTLK] NewtSync"
• Previous message: L A GREEN: "Re: [NTLK] .sit files, how do you install them?"
• In reply to: Eric Schneck: "Re: [NTLK] Small part needed"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]
• Mail actions: [ respond to this message ] [ mail a new topic ]

04-01-16 15.54, skrev Eric Schneck på eschneck_at_mindspring.com följande:

> Are you sure those are cracks and not molding lines? Mine has two lines that
> run from the circular opening towards the outside corners.

yes, after a closer look, youre right - theyre not cracks, actually.

-- 
This is the NewtonTalk list - http://www.newtontalk.net/ for all inquiries
List FAQ/Etiquette/Terms: http://www.newtontalk.net/faq.html
Official Newton FAQ: http://www.chuma.org/newton/faq/

• Next message: Anil: "Re: [NTLK] NewtSync"
• Previous message: L A GREEN: "Re: [NTLK] .sit files, how do you install them?"
• In reply to: Eric Schneck: "Re: [NTLK] Small part needed"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]
• Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2.1.5 : Fri Jan 16 2004 - 10:00:02 PST