Re: [NTLK] Small part needed

From: Eric Schneck (eschneck_at_mindspring.com)
Date: Fri Jan 16 2004 - 06:54:12 PST

• Next message: Goodwin, Greg: "[NTLK] Memory Cards - What is reasonable?"
• Previous message: Thomas Hart: "Re: [NTLK] NewtSync"
• Maybe in reply to: Ray Zschau: "[NTLK] Small part needed"
• Next in thread: doppler: "Re: [NTLK] Small part needed"
• Reply: doppler: "Re: [NTLK] Small part needed"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]
• Mail actions: [ respond to this message ] [ mail a new topic ]

>Date: Fri, 16 Jan 2004 11:37:43 +0100
>Subject: Re: [NTLK] Small part needed
>From: doppler <roman_at_pixell.net>

>> I'm just a few days away from cracking open my 2100 to install a
>> SER-001. While looking it over for any problems, I noticed that the
>> little part that slides out of the top of the lid to hold the stylus is
>> starting to crack.

> That part has metal inside, it won't break.

>ive got three newts, they all show tiny cracks but dont break, i think youre
>safe there.

Are you sure those are cracks and not molding lines? Mine has two lines that run from the circular opening towards the outside corners.

Eric

-- 
This is the NewtonTalk list - http://www.newtontalk.net/ for all inquiries
List FAQ/Etiquette/Terms: http://www.newtontalk.net/faq.html
Official Newton FAQ: http://www.chuma.org/newton/faq/

• Next message: Goodwin, Greg: "[NTLK] Memory Cards - What is reasonable?"
• Previous message: Thomas Hart: "Re: [NTLK] NewtSync"
• Maybe in reply to: Ray Zschau: "[NTLK] Small part needed"
• Next in thread: doppler: "Re: [NTLK] Small part needed"
• Reply: doppler: "Re: [NTLK] Small part needed"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]
• Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2.1.5 : Fri Jan 16 2004 - 10:00:01 PST