From: Robert Benschop (rbenschop_at_telebyte.nl)
Date: Wed Jun 09 2004 - 22:46:53 PDT
On 10-jun-04, at 0:36, Frank Gruendel wrote:
> I have it due to a rare streak of luck at eBay. I just
> downloaded the driver, it works fine with the card. The card came with
> an
> adapter
> that had a VGA and a small round connector, the small round one
> goes into a TV set. Works perfectly. There is also a cinch connector
> that's probably for sound. Are the Newton sounds routed through the
> card and go into the PC or Mac if connected with the right cable?
> It took me some time to figure out how to start the output to the
> TV set. When the card is inserted three veeery tiny buttons appear at
> the top of the screen. Tiny enough to not notice them for quite some
> time. The leftmost one is for switching the display on the TV on
> and off, but what are the other two buttons for?
Not sure which card you have, maybe you can tell what it says on the
card?
In case this is the EZ2TV be careful to use it only with the adapter
attached, apparently the card can fry your Newt without...
Robert Benschop
-- This is the NewtonTalk list - http://www.newtontalk.net/ for all inquiries Official Newton FAQ: http://www.chuma.org/newton/faq/ WikiWikiNewt for all kinds of articles: http://tools.unna.org/wikiwikinewt/
This archive was generated by hypermail 2.1.5 : Wed Jun 09 2004 - 23:00:01 PDT