Re: [NTLK] eMate disassembly - do I *have* to de-solder?/my emate just came

From: Woody Smith (woody_at_bitstream.net)
Date: Wed May 26 2004 - 16:34:11 PDT

• Next message: Brian: "Re: [NTLK] eMate disassembly"
• Previous message: Brian: "Re: [NTLK] password breaker-Emate"
• In reply to: Dan: "Re: [NTLK] eMate disassembly - do I *have* to de-solder?/my emate just came"
• Next in thread: Martin Joseph: "Re: [NTLK] eMate disassembly - do I *have* to de-solder?/my emate just came"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]
• Mail actions: [ respond to this message ] [ mail a new topic ]

I use the lowest temp silver solder that I can get, but the wires are
only surface soldered and will release with the lightest touch of the
iron/gun. Re-solder is just as easily, red on right.
Woody
On Wednesday, May 26, 2004, at 05:39 PM, Dan wrote:

> Yes I figgured that after reading Frank's instructions. But it does
> sound
> like it would be easier to desolder the two wires *sigh*. I will take
> a
> look and see how hard it is when I get in there. One question though,
> what
> solder do you recommend for the emate? Anything specific?
>
> -Dan

-- 
This is the NewtonTalk list - http://www.newtontalk.net/ for all inquiries
Official Newton FAQ: http://www.chuma.org/newton/faq/
WikiWikiNewt for all kinds of articles: http://tools.unna.org/wikiwikinewt/

• Next message: Brian: "Re: [NTLK] eMate disassembly"
• Previous message: Brian: "Re: [NTLK] password breaker-Emate"
• In reply to: Dan: "Re: [NTLK] eMate disassembly - do I *have* to de-solder?/my emate just came"
• Next in thread: Martin Joseph: "Re: [NTLK] eMate disassembly - do I *have* to de-solder?/my emate just came"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]
• Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2.1.5 : Wed May 26 2004 - 17:00:02 PDT