From: Frank Gruendel (newtontalk_at_pda-soft.de)
Date: Sat Apr 16 2005 - 06:25:45 PDT
The two packs are electrically almost identical, but
physically different. It wouldn't probably be much
of a problem to unsolder the wires from the eMate
pack and solder them to the 2x00 pack. Before
this is attempted, it is advisable to check if
the connector on the eMate mainboard is wired in
a way that ground is connected to one side of the
temperature resistor. This is definitely the case
inside the 2x00 pack and definitely not inside
the eMate pack, hence such a project would only
result in something that's electrically identical if
this connection is present on the eMate's=20
power connector.
Frank
-- Newton software and hardware at http://www.pda-soft.de
-- This is the NewtonTalk list - http://www.newtontalk.net/ for all inquiries Official Newton FAQ: http://www.chuma.org/newton/faq/ WikiWikiNewt for all kinds of articles: http://tools.unna.org/wikiwikinewt/
This archive was generated by hypermail 2.1.5 : Sat Apr 16 2005 - 08:00:01 PDT