From: Paul Curtis (Nations One Mortgage) (MicroSSG_at_Comcast.net)
Date: Sat May 07 2005 - 19:12:18 PDT
Try lining up the ports in as direct a line of sight as possible and give it
some room, something like 3-6 inches. I use my cloth for cleaning my
eye-glasses to prop the 2100 just so.
Best Regards,
Paul Curtis
Certified Mortgage Planner
BBC Group, a division of Nations One Mortgage
(517) 775-6666 Cell (Voice Mail)
(517) 579-3283 Office
(866) 263-2956 Toll-Free Office
(517) 548-9735 Facsimile
Curtis_at_BBCGroupMI.com
-----Original Message-----
From: newtontalk-bounce_at_newtontalk.net
[mailto:newtontalk-bounce_at_newtontalk.net] On Behalf Of Moe
Sent: Saturday, May 07, 2005 1:04 PM
To: newtontalk_at_newtontalk.net
Subject: Re: [NTLK] IRDA installation problems
No CPU upgrades, only RAM. But I'd love to get my hands on the 240 or
320Mhz G3 (wink wink nudge nudge if anyone has one ;) ). I'll try some of
these suggestions, but maybe an OS reinstall is in order...=20 Either that
or the IR port is worn out?
Morris
On 5/7/05, Vincent Lee <vincent_at_whitespaces.org> wrote:
> My Powerbook 2400c/180 with OS 9.1 has no problem with DIL via IrDA.
>=20
> If there is no HW and SW( include OS ) problem, then just try to place
>your Newton at same height with Powerbook's IrDA port and around 4 inch
>far from Powerbook. ( I have some experiences that Diconnection dialog
>pops up when my Newton IrDA port is placed lower/higher than
>Powerbook's IrDA/or too close ) =20 Vincent =20 =20
> --
> This is the NewtonTalk list - http://www.newtontalk.net/ for all
>inquirie=
s
> Official Newton FAQ: http://www.chuma.org/newton/faq/ WikiWikiNewt for
> all kinds of articles: http://tools.unna.org/wikiwikinew=
t/
>=20
>
-- This is the NewtonTalk list - http://www.newtontalk.net/ for all inquiries Official Newton FAQ: http://www.chuma.org/newton/faq/ WikiWikiNewt for all kinds of articles: http://tools.unna.org/wikiwikinewt/ -- This is the NewtonTalk list - http://www.newtontalk.net/ for all inquiries Official Newton FAQ: http://www.chuma.org/newton/faq/ WikiWikiNewt for all kinds of articles: http://tools.unna.org/wikiwikinewt/
This archive was generated by hypermail 2.1.5 : Mon May 09 2005 - 02:00:01 PDT