From: Jake Bordens (newton_at_allaboutjake.com)
Date: Mon Oct 10 2005 - 15:18:45 PDT
On Oct 6, 2005, at 3:53 PM, DJ Vollkasko wrote:
> Could you take some snaps of the assempled thing? How much does the
> antenna
> stick out of the case? How'd you deal with the shielding inside the
> Newt
> (Eckhart wrote something about this in his "old" blog, see archived
> posts at
> his blog)
Here's a photo of the bt-001 prototype installed in a MP2000+.
http://www.allaboutjake.com/newton/bt-001-installed.jpg
My next prototype will look something like this installed:
http://www.allaboutjake.com/newton/v2%20mockup-installed.jpg
The v2 module is a class 2 module and is bigger than the class 1
module used in the bt-001 board. You'll note that clearances are
close with this design, but it should work. That's why I mocked it
up in cardboard. :)
Jake
-- This is the NewtonTalk list - http://www.newtontalk.net/ for all inquiries Official Newton FAQ: http://www.chuma.org/newton/faq/ WikiWikiNewt for all kinds of articles: http://tools.unna.org/wikiwikinewt/
This archive was generated by hypermail 2.1.5 : Mon Oct 10 2005 - 21:00:06 PDT
