I suspect that it is a problem with the USB/serial software. For the
Keyspan driver it is recommended that you either install in in OS X
or Classic but not both.
I sounds like you have successfully installed it in OS X. ...... Not
a problem.If Escale works for you good. else use NewTen to install
packages.
get the ethernet packages installed and connect to Classic via
Appletalk, You will need a PCMCIA ethernet card and a Hub or
switcher and NCU will fly. Direct ethernet connects seem to be
problematic. Re pcmcia I have had good luck with the 3Com Megahertx
3CXE589ET though I think any of the 589 series cards will work but
some need a dongle that may not be provided.
If you need a card write me off list I can often find them at a local
used computer store.
Woody
On Aug 11, 2006, at 6:31 PM, Steven Combs wrote:
> K...I've completed the battery AA replacement on my eMate. I've
> received my Newton connection cable from MAC Mall (see an earlier
> message). I can connect using eScale under MAC OS X using a USB to
> serial Keyspan cable, but I can't get NCU under MAC OS 9 in Classic
> mode to recognize the cable or see the eMate. Is there something I
> need to do under Classic mode to "see" the serial device?
>
> Any thoughts anyone?
>
> Thanks,
> Steven
-- This is the NewtonTalk list - http://www.newtontalk.net/ for all inquiries Official Newton FAQ: http://www.chuma.org/newton/faq/ WikiWikiNewt for all kinds of articles: http://tools.unna.org/wikiwikinewt/Received on Sat Aug 12 00:08:11 2006
This archive was generated by hypermail 2.1.8 : Sun Aug 13 2006 - 18:30:00 EDT