On Sunday, December 22, 2002, at 12:06 AM, Victor Rehorst wrote:
>
> John Acuff wrote:
>> I just received my 3Com 3CCE589ET ethernet card from our own Simon
>> Muller(thanks Simon!), and went to the chuma ethernet set up page to
>> get it all working. I had NIE 2.0, as well as Newton Internet 2.0
>> installed. So I installed the Newton Devices package, and the 3Com 589
>> driver, the 3Com addon package, and the Farallon driver package. Then
>> I
>> inserted the card and the Newt identified it as a "3Com Megahertz"
>> card. So far, so good. I then went into Internet Setup to create a new
>> set up. However, in the "connect using" box, I don't get the ethernet
>> option. After going back over the instructions, I noticed a mention
>> of
>> an NIE Ethernet package, but I don't see that on my Newt, and I can't
>> find it on my UNNA cd's. Is this the missing piece of the puzzle? And
>> where can I find it?
>
> That's the missing piece, yes. You can get it here:
>
> http://www.unna.org/unna/apple/software/Internet/NIE2/ENETSUP/
> enetsup.pkg
>
Thanks Victor. That was it. I never thought to look there. I was
looking under "drivers", and "internet". Never thought about looking
under "apple"!
Thanks again!
John
"Got Newt!"
-- This is the NewtonTalk list - http://www.newtontalk.net/ for all inquiries List FAQ/Etiquette/Terms: http://www.newtontalk.net/faq.html Official Newton FAQ: http://www.chuma.org/newton/faq/
This archive was generated by hypermail 2.1.2 : Wed Jan 01 2003 - 10:02:50 EST