Actually, they should slide in to the ends. Once you get the long sides in,
you can finangle one end and then the other end underneath the case.
-V
Original Message:
-----------------
From: Michael Mays chaosmonk_at_earthlink.net
Date: Fri, 24 May 2002 14:47:45 -0500
To: newtontalk_at_newtontalk.net
Subject: Re: [NTLK] NuShield
It's a bit hard to explain...allright, you've got your rectangular=3D
NuShield, with the long sides being slightly curved so as to fit=3D
underneath the long edges of the screen. The part I had to trim was not=3D
the curved side, but the flat one that corresponds to the short edges.=3D
According to the instructions I was sent, those ends do not get tucked=3D
under the screen. They were cut a millimeter or two too long to fit in=3D
the screen.
--------------------------------------------------------------------
mail2web - Check your email from the web at
http://mail2web.com/ .
-- Read the List FAQ/Etiquette: http://www.newtontalk.net/faq.html Read the Newton FAQ: http://www.guns-media.com/mirrors/newton/faq/ This is the NewtonTalk mailing list - http://www.newtontalk.net
This archive was generated by hypermail 2.1.2 : Wed Jun 12 2002 - 20:02:43 EDT