I gave that a bit of a try before trimming it, though not much. This one's=
working fine for now, so I suppose I'll work harder on getting those ends=
in on the next one before resorting to permanent measures. :) I hope my=
trimming isn't responsible for the haziness of the screen, though. I=
suppose I'll just have to wait and see. Thanks for everyone's help.
Michael Mays
*********** REPLY SEPARATOR ***********
On 5/24/2002 at 4:05 PM victor_at_newtontalk.net wrote:
>Actually, they should slide in to the ends. Once you get the long sides
>in,
>you can finangle one end and then the other end underneath the case.
>
>-V
>
>Original Message:
>-----------------
>From: Michael Mays chaosmonk_at_earthlink.net
>Date: Fri, 24 May 2002 14:47:45 -0500
>To: newtontalk_at_newtontalk.net
>Subject: Re: [NTLK] NuShield
>
>It's a bit hard to explain...allright, you've got your rectangular=3D3D
> NuShield, with the long sides being slightly curved so as to fit=3D3D
> underneath the long edges of the screen. The part I had to trim was
>not=3D3D
> the curved side, but the flat one that corresponds to the short=
edges.=3D3D
> According to the instructions I was sent, those ends do not get=
tucked=3D3D
> under the screen. They were cut a millimeter or two too long to fit=
in=3D3D
> the screen.
>
>
>
>--------------------------------------------------------------------
>mail2web - Check your email from the web at
>http://mail2web.com/ .
>
>
>--
>Read the List FAQ/Etiquette: http://www.newtontalk.net/faq.html
>Read the Newton FAQ: http://www.guns-media.com/mirrors/newton/faq/
>This is the NewtonTalk mailing list - http://www.newtontalk.net
-- Read the List FAQ/Etiquette: http://www.newtontalk.net/faq.html Read the Newton FAQ: http://www.guns-media.com/mirrors/newton/faq/ This is the NewtonTalk mailing list - http://www.newtontalk.net
This archive was generated by hypermail 2.1.2 : Wed Jun 12 2002 - 20:02:43 EDT