Re: [NTLK] Soldering the Interconnect Port

From: Johannes Wolf (mp2100_at_mail-gw.estec.esa.nl)
Date: Mon Apr 07 2003 - 07:18:24 PDT

• Next message: Eric L. Strobel: "Re: [NTLK] Soybo"
• Previous message: Patrick Jendraszak: "Re: [NTLK] FS: Newton Gear"
• In reply to: Eric Schneck: "Re: [NTLK] Soldering the Interconnect Port"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]
• Mail actions: [ respond to this message ] [ mail a new topic ]

You might inspect the solder connections of the connector housing and
reinforce them with additional or re-soldering.

> -----Original Message-----
> [mailto:newtontalk-bounce_at_newtontalk.net]On Behalf Of Eric Schneck
> Sent: Monday, April 07, 2003 3:55 PM
> Subject: Re: [NTLK] Soldering the Interconnect Port

> Is there an easy way to reinforce the interconnect port *before*
> it breaks?

> Eric

-- 
This is the NewtonTalk list - http://www.newtontalk.net/ for all inquiries
List FAQ/Etiquette/Terms: http://www.newtontalk.net/faq.html
Official Newton FAQ: http://www.chuma.org/newton/faq/

• Next message: Eric L. Strobel: "Re: [NTLK] Soybo"
• Previous message: Patrick Jendraszak: "Re: [NTLK] FS: Newton Gear"
• In reply to: Eric Schneck: "Re: [NTLK] Soldering the Interconnect Port"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]
• Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2.1.5 : Mon Apr 07 2003 - 08:30:00 PDT