Re: [NTLK] Soldering the Interconnect Port

From: Eric Schneck (eschneck_at_mindspring.com)
Date: Mon Apr 07 2003 - 06:55:25 PDT

• Next message: Patrick Jendraszak: "Re: [NTLK] FS: Newton Gear"
• Previous message: Joel M. Sciamma: "[NTLK]"
• Maybe in reply to: Hans Derycke: "[NTLK] Soldering the Interconnect Port"
• Next in thread: Johannes Wolf: "Re: [NTLK] Soldering the Interconnect Port"
• Reply: Johannes Wolf: "Re: [NTLK] Soldering the Interconnect Port"
• Reply: Sunder: "Re: [NTLK] Soldering the Interconnect Port"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]
• Mail actions: [ respond to this message ] [ mail a new topic ]

Is there an easy way to reinforce the interconnect port *before* it breaks?

Eric

>From: Hans Derycke (hans_at_derycke.com)
>Date: Fri Apr 04 2003 - 13:32:58 PST

>Thanks to the good directions over at pda-soft.de, my UMP is >open and gutted on my desk. Now comes the part where I'm >supposed to solder the interconnect port back onto the main >logic board.
--------------------------------------------------------------------------------

-- 
This is the NewtonTalk list - http://www.newtontalk.net/ for all inquiries
List FAQ/Etiquette/Terms: http://www.newtontalk.net/faq.html
Official Newton FAQ: http://www.chuma.org/newton/faq/

• Next message: Patrick Jendraszak: "Re: [NTLK] FS: Newton Gear"
• Previous message: Joel M. Sciamma: "[NTLK]"
• Maybe in reply to: Hans Derycke: "[NTLK] Soldering the Interconnect Port"
• Next in thread: Johannes Wolf: "Re: [NTLK] Soldering the Interconnect Port"
• Reply: Johannes Wolf: "Re: [NTLK] Soldering the Interconnect Port"
• Reply: Sunder: "Re: [NTLK] Soldering the Interconnect Port"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]
• Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2.1.5 : Mon Apr 07 2003 - 14:30:00 PDT